Requirements
1.Backup any important data from
your Samsung Galaxy Note 3 as a complete wipe will be required during the
flashing process.
2.Enable USB debugging option
on your
device: Settings > Development Options > USB
debugging.
3.Your device must be charged to at
least 60% of power.
Installing
firmware on Galaxy Note3 for all models
Before proceeding to install stock
firmware on Galaxy Note 3, check your Note’s model number: Settings >
General > About. Then download the firmware for your model of
Galaxy Note .
- Galaxy Note 3 SM-N900
- Galaxy Note 3 Duos SM-N9002
- Galaxy Note 3 SM-N900W8
- Galaxy Note 3 LTE SM-N9005
- Galaxy Note 3 SM-N900S
- T-Mobile Galaxy Note 3 SM-N900T
- Sprint Galaxy Note 3 SM-N900P
Flashing Software
Steps to Install
• Install Odin on your
computer and launch it.
• Switch your Samsung Galaxy
Note 3 off and boot it in Download mode: press and hold Volume Down, Power and
Home buttons together. When connected successfully, you will get a message in
Odin saying Added!!. (In case you don’t get it, try another USB port. If that
doesn’t help either, then re-install USB drivers).
• In Odin make sure that the
Auto Reboot and F. Reset Time check boxes are the only options checked and
nothing else is.
• Click on PDA on Odin, locate the
.tar.md5 file and hit the Start button to initiate the update process.
• When official update
installation is successfully completed, on Odin ID:COM will turn green and Odin
will show you a PASS message.
First boot takes a bit of while to
load things up.
No comments:
Post a Comment